Kenton Juno 60 MIDI Kit

591,23

(TTC)

Ajouter au panier

Numéro d'article: 72099

Inventaire du magasins

Valenciennes Pas en stock Demain ouvre à partir de 15:00
Belgique
Saint-Nicolas XXL En stock Mardi ouvre à partir de 10:00
Anvers XXL Pas en stock Ouverte jusqu'a 18:00 hr
Bruges Pas en stock Ouverte jusqu'a 18:00 hr
Bruxelles Pas en stock Ouverte jusqu'a 18:00 hr
Gand Pas en stock Demain ouvre à partir de 10:00
Hasselt Pas en stock Mardi ouvre à partir de 10:00
Herentals Pas en stock Mardi ouvre à partir de 10:00
Louvain Pas en stock Demain ouvre à partir de 10:00
Liège Pas en stock Demain ouvre à partir de 14:00
Malines Pas en stock Demain ouvre à partir de 10:00
Roulers Pas en stock Demain ouvre à partir de 10:00
Pays-Bas
Eindhoven XXL Pas en stock Fermé
Rotterdam XXXL Pas en stock Fermé
Amsterdam XL Pas en stock Fermé
The DJGear Shop - Amsterdam NEW Pas en stock Fermé
La Haye Pas en stock Fermé
Deventer Pas en stock Fermé
Groningen Pas en stock Fermé
Heerlen Pas en stock Fermé
Leeuwarden Pas en stock Fermé
Utrecht Pas en stock Fermé

Général

Kenton Juno 60 MIDI Kit

Retrofit Kit
his retrofit kit for the Roland Juno-60 adds the following MIDI control:

For incoming MIDI:
• Any MIDI channel can be selected
• Notes (MIDI note numbers 36 – 96) – transpose possible
• Program change (numbers 1 – 40)
• Pitchbend – (bends up and down a fifth)
• Mod Wheel
• Filter cutoff frequency (of low pass filter)
• Volume
• Sustain (decay on-off)
• Arpeggio clock synced to MIDI clock

By default:
• Pitchbend is controlled by pitchbend messages
• Mod wheel is controlled by Mod Wheel (CC#1) and also by Aftertouch messages
• Filter cutoff is controlled by CC#16
• Volume is controlled by MIDI volume (CC#7)
• Sustain is controlled by Sustain (CC#64)

however, any controller or aftertouch or velocity can be mapped to control other things so for example velocity could be mapped to control volume.

For outgoing MIDI:
• Any MIDI channel can be selected
• Notes (MIDI note numbers 36 – 96) – transpose possible
• Program changes 1 to 61 can be sent using a button press followed by a key press
• No other MIDI can be sent – the retrofit is primarily intended to allow the synth to be played from a MIDI master keyboard or sequencer.

Hardware:
• MIDI In, Out & Thru sockets
• Push button (for programming the MIDI setup)
• Setups are stored in non-volatile memory (Eeprom)

The kit comprises the following items:
• Circuit board – fits in the base of the Juno-60
• Small pack – contains DIN sockets and mounting hardware
• Large pack – contains cable assemblies
• User instructions – How to change from default settings and general instructions
• Fitting instructions – step by step fitting guide plus diagrams of where to connect what

All kits are fully checked and tested before despatch

Note: Our retrofit kits are not intended for installation by the end user. They should always be fitted by an experienced synth engineer.